Sharp XE-A113 Bedienungsanleitung Seite 79

Removing the paper roll
When a red dye appears on the paper roll, it is time to replace it. Replace the paper roll with a new one. If you
plan on not using the register for an extended period of time, remove the paper roll, and store it in an appropriate
place.
Caution: The paper cutter is mounted on the printer cover. Be careful not to cut yourself.
When not using the take-up spool (using as receipt paper):
Print roller
release lever
When using the take-up spool (using as journal paper):
Installing the paper roll
For information on how to install paper rolls, refer to "Installing a Paper Roll" on page 10.
Caution: The paper cutter is mounted on the printer cover. Be careful not to cut yourself.
1.
Print roller arm
2.
3.
1.
Area to cut
2.
3.
4.
5.
6.
1 2
Part Part
Remove the printer cover.
Lift up the print roller release lever to unlock and open the print
roller arm.
Remove the paper roll from the paper roll cradle.
Do not pull the paper through the printer.
Turn the mode switch to a position other than "
power cord connected.
Remove the printer cover.
F
Press the key to advance the journal paper until its printed
part is out of the way.
Cut the paper and remove the take-up spool.
Lift up the print roller release lever to unlock and open the print
roller arm.
Remove the paper roll from the paper roll cradle.
Do not pull the paper through the printer.
7.
Remove the outer side of the take-up spool as shown
on the left.
8.
Remove the printed journal roll from the take-up spool.
3
FOR THE MANAGER
Part
" with the
77