ECOVACS deebot 8 Benutzerhandbuch Seite 11

4 Charge DEEBOT 8
Place DEEBOT 8 on the Charging Dock
making sure the Charging Contacts on
DEEBOT 8 and the Charging Dock Pins
make a connection.
Charge DEEBOT 8 for at least 12 hours
before the first use.
The START/PAUSE Button on the robot's Control Panel blinks when DEEBOT 8 is charging
*
and stays on when DEEBOT 8 is fully charged.
If DEEBOT 8's START/PAUSE Button Blinks RED while charging, move the Bottom Power
*
Switch to the ON position.
Remove DEEBOT 8's battery if the robot will not be used for a long time. In case of battery
*
leakage, please remove the battery and wipe the battery slot clean while wearing protective
gloves.
If battery is fully discharged or not used for a long time, its capacity may decrease and need to be
*
reactivated.
*
To reactivate the battery: Place the robot on the Charging Dock by hand, remove after
charging for 3 minutes; repeat 3 times, then charge normally for 3-5 hours.
DEEBOT 8 uses a long life battery, and does not require frequent replacement. To replace
*
the battery, contact Customer Service or follow the below instructions:
a. Unscrew the Battery Cover Screws, remove Battery Cover.
b. Remove the battery and disconnect the fasteners.
c. Connect the corresponding positive and negative fasteners on the new battery. Insert the
new battery, reassemble the Battery Cover and screw in the Battery Cover Screws.
Attach a Cleaning Cloth
5
To use DEEBOT 8's optional mopping
feature, attach a selected Cleaning Cloth
before use. When using the mopping feature,
fold area rug edges under themselves so
DEEBOT 8 avoids the rug.
Attach the selected Cleaning Cloth to the
*
Cleaning Cloth Plate.
Insert the Cleaning Cloth Plate tabs into the
*
Cleaning Cloth Plate Slots on the bottom of
DEEBOT 8 until you hear a click.
3. Operating and Programming
9
EN