Connect Ir Equipment; Connect The Trigger Output; Connect To Ac Power - Harman Kardon AVR 1710 Handbuch

AVR

Connect IR Equipment

the AVr is equipped with a remote Ir Input connector that lets you remotely control the
AVr in a variety of situations:
• when you place the AVr inside a cabinet or facing away from the listener, connect
an external Ir receiver, such as the optional harman kardon he 1000, to the AVr's
Ir In jack.
external Ir
receiver
AVr and Source devices
Installed Inside of cabinet
• If you install a multizone system (AVr 1710/AVr 171 only), connect an Ir control
device to the zone 2 Ir In connector for remote-room control of the multizone
system, source devices and volume in the remote zone.
external Ir receiver
If a source device is shared with the main listening area, any control commands issued
to that source will also affect the main room.
20
AVr Ir In Jack
zone 2 Speakers
Zone 2
Main Room
AVr

Connect the Trigger Output

If your system has equipment that can be controlled by a dc trigger signal, connect it to
the AVr's trigger out connector with a mono 1/8-inch (3.5mm) mini-plug interconnect
cable. the AVr will supply a 12V dc (100mA) trigger signal at this connection whenever
it is powered on.
Mono 1/8-inch (3.5mm)
Mini-plug Interconnect
(not supplied)

Connect to AC Power

AVR 171/AVR 161:
connect the supplied Ac power cord to the AVr's Ac Input connector and then to a
working, non-switched Ac power outlet.
AVr
Ac Input
connector
power cord (supplied)
AVR 1710/AVR 1610:
connect the AVr's power cord to a working, non-switched Ac power outlet.
Power Cord
Making Connections
AVr
device with
trigger In connector
Ac power
AC Power
AVR
outlet
Outlet