Installation Bullet Camera - Technaxx TX-50 Bedienungsanleitung

3 Installation Bullet Camera for TX-50 & TX-51
Important: Make sure the installation surface can min support the 3x the weight of
the camera and the bracket.
If you drill a hole in the wall, make sure that power cables, electrical cords and/or
pipelines are not damaged. When using the supplied mounting material, we do not take
the liability for a professional installation. You are entirely responsible to ensure that the
mounting material is suitable for the particular masonry, and that the installation is done
properly. When working at higher altitudes, there is danger of falling! Therefore, use
suitable safeguards.
Step 1: Before you install the bracket, pull the cable through the cable exit of the
bracket chassis.
Install the expansion bolt if you want to install in the cement wall (make sure the
installation holes of the expansion bolts are the same with the bracket.) Then you can
install the bracket. If you want to install in the wood surface, skip the first step and then
use the self-tapping screws to install the bracket directly.
7