Installation Dome Camera - Technaxx TX-50 Bedienungsanleitung

6 Installation Dome Camera for TX-50 & TX-51
Important: Make sure the installation surface can min support the 3x the weight of
the camera and the bracket.
If you drill a hole in the wall, make sure that power cables, electrical cords and/or
pipelines are not damaged. When using the supplied mounting material, we do not take
the liability for a professional installation. You are entirely responsible to ensure that the
mounting material is suitable for the particular masonry, and that the installation is done
properly. When working at higher altitudes, there is danger of falling! Therefore, use
suitable safeguards.
The dome camera usually mainly uses the in-ceiling installation. It can be installed on
the ceiling or the wall.
 For side exit cable installation, make sure the side exit cable direction is the same
as shown in the installation position map.
 Before you secure the screws on the pedestal, put the cable through the cable exit
of the pedestal.
 Before you complete the installation and debug, do not remove the electrostatic film.
After you remove the film, do not touch the enclosure in case there is any scratch.
Step 1: Take the installation position map from the accessories bag and then put it on
the surface of the ceiling or the wall according to the cable exit position. Dig three holes
according to the installation position map and then take three expansion bolts from the
accessories bag and put them to the holes you just dug.
12