Note - Technaxx TX-50 Bedienungsanleitung

Click Iris "+" to open menu or confirm current operation.
Click Iris "-" to realize auto focus.
Click up/down button to view all the items on the left pane of the following list. Click
left/right button to set the corresponding values on the right pane of the following list. If
there is " ", click confirm button to go to the 2nd menu. Repeat the previous steps to
set detailed value. Click Return button to go back to the previous menu interface.
Click Zoom "+" to zoom in and click Zoom "-" to zoom out.

4.2 Note

Brightness It is to adjust monitor window bright. The value ranges from 0 to 100.
The default value is 50. The larger the number is, the bright the video is.
When you input the value here, the bright section and the dark section
of the video will be adjusted accordingly. You can use this function
when the whole video is too dark or too bright. Note the video may
become hazy if the value is too high. The recommended value ranges
from 40 to 60.
Contrast It is to adjust monitor window contrast. The value ranges from 0 to 100.
The default value is 50. The larger the number is, the higher the contrast
is. You can use this function when the whole video bright is OK but the
contrast is not proper. Note the video may become hazy if the value is
too low. If this value is too high, the dark section may lack brightness
while the bright section may over exposure .The recommended value
ranges from 40 to 60.
Saturation It is to adjust monitor window saturation. The value ranges from 0 to
100. The default value is 50. The larger the number, the strong the color
is. This value has no effect on the general brightness of the whole video.
The video color may become too strong if the value is too high. For the
grey part of the video, the distortion may occur if the white balance is not
accurate. Note the video may not be attractive if the value is too low.
The recommended value ranges from 40 to 60.
Sharpness The value here is to adjust the edge of the video. The value ranges from
0 to 100. The larger the value is, the clear the edge is and vice versa.
Note there is noise if the value here is too high. The default value is 50
and the recommended value ranges from 40 to 60.
3DNR It is to reduce video noise. The larger the number is, the lower the noise
is. The details of the video may disappear if the value here is too large.
Anti-flicker  Outdoor: In this mode, you can switch exposure mode to get the
effect under the corresponding exposure mode.
 50Hz: When the current is 50Hz, system can auto adjust the
exposure according to the environment brightness in case there is
any strip.
 60Hz: When the current is 60Hz, system can auto adjust the
exposure according to the environment brightness in case there is
any strip.
10