Technaxx TX-50 Bedienungsanleitung Seite 13

Step 2: Use inner hex wrench to remove the three case locking screws and then
remove the dome enclosure.
Step 3: Adjust the pedestal position according to the cable exit mode (ceiling/side). Pull
the cable through the cable side exit at the installation surface and the pedestal (skip
this step if you want to use ceiling exit mode). Line up the screw holes at the bottom of
the pedestal to the expansion bolts in the installation surface. Put three self-tapping
screws to expansion bolts and then secure firmly. Now the pedestal is on the installation
surface.
Step 4: Connect the video output port of the device cable to the HDCVI DVR, and
connect the power port of the device cable to the power. After the image is shown on
the HDCVI DVR, control the interface by HDCVI series DVR PTZ, adjust lens zoom by
using coaxial control, and the camera will auto focus to the best position.
Step 5: Use three case locking screws to secure the dome housing on the pedestal.
Now you have completed the device installation and cable connection. You can use the
terminal encode devices to view the monitor video.
13