Conrad 75 17 16 Bedienungsanleitung Seite 31

However, most routers can determine a certain range, e.g. end digits 10-50 or 1-20 or such-
like. For the camera a digit out of the possible address range must be used of course.
for it to be recognised.
However, normally the basic setting of a router provides the IP addresses starting with the
end digit 2 (end digit 1 usually is the router) and the end digit is 254.
Therefore enter e.g. "200" as the last digit of the IP address when you use a router, to avoid
conflict of addresses.
A definite IP address is suggested for this camera since otherwise, a new IP address may
be allocated to the camera with every reboot of the router.
• Click "ACCESS POINT SEARCH" to have the cam-
era list any access points available in the area.
• Click the access point you would like to use. The
SSID name is displayed on the right.
Figure F
Figure G
31