Conrad 75 17 16 Bedienungsanleitung Seite 30

• Select the MAC address; Under "Network Setting"
at the right, the following information appears: IP,
Net Mask, Gateway, Port Number 1, Camera Name
(see figure D).
• Details appear on the right.
• Select "WLAN" and, where required, adjust the IP
address, net mask, gateway and camera name and
click "SETUP" to save the settings.
Please note: Any IP address must only be provided once in each network. The first three
digits must be the same in the network (e.g. 192.168.1.x, in which "x" may be between 1
and 254). The subnet must also be set up correspondingly for all devices (e.g.
255.255.255.0).
In case you use a router that automatically supplies IP addresses (a so-called DHCP serv-
er), you may find the IP address range the router is using in the MS-DOS prompt.
Start the MS-DOS prompt (e.g. in Windows XP under "START", then "Programme", then
"Accessories" and finally click on "Prompt") and enter "ipconfig".
Subsequently the IP address under which your computer can be reached, the subnet and
the standard gateway appear.
When the prompt e.g. shows 192.168.0.3 as the IP address of your computer, you set up
e.g. 192.168.0.200 for your camera (the first three digits must always be the same as your
computer, the last digit must be different).
Don't forget that, depending on the connected computers, a router may automatically pro-
vide the last digit of the IP address, which also depends on the setting of the router (nor-
mally the end digit 1 is the router, the end digit 2 the first connecter computer in the net-
work, etc.)
30
Figure D
Figure E