Conrad 75 17 16 Bedienungsanleitung Seite 32

• Enter the access information for the access point
and click "APPLY" to save the configuration.
• Take the WLAN camera out of service (remove
mains adapter) and remove the power cable.
• Set the "LAN/WLAN" slider (10) to "WLAN" and
then activate the camera again (connect mains
adapter).
• Verify your access point on functionality of the con-
figuration.
* Click "AUTO DETECT" again, and the new network
information is displayed (this display may take up to 30
or 60 seconds).
• Select the Mac address and click "Connect" (upper
right).
• When the network and the camera are configured
correctly, a window appears requesting user name
and password.
Enter "root" as user name and "admin" as password.
• Depending on the security settings of your internet browser an error message appears, stating that a
required ActiveX gate cannot be installed or from Internet Explorer, and that the installation of the
ActiveX gate can be started manually by clicking on the information bar.
32
Figure H
Figure I
Figure J