roco BR 120 Bedienungsanleitung Seite 20

Attention!
Only Märklin* locomotives are included in the Mär-
klin* Mobile Station Databank.
For docking Roco Locomotives in the Märklin*-
Mobile Station, use one of the two universal numbers
36330/37962. They are to be set this way:
Dock the locomotive in the databank:
1.
2.
3.
4.
5.
6.
7.
GB
8.
Setting the Correct Address:
1.
2.
3.
4.
5.
6.
7.
In the case that the locomotive does not run, erase
the locomotive from the databank:
1.
2.
3.
4.
Repeat the steps
Repeat the steps "Dock the Locomotive in the da-
tabank" (1-8) and "Setting the Correct Address" (1-7)
Should there still be problems, delete the locomotive
from the databank again.
Repeat the steps
"Dock the Locomotive in the databank" (1-8), except
that at step 5 you go to the menu option ("Address"),
and at step 7 you should set the address of your lo-
comotive.
Look for the desired symbol with the knob, and con-
firm your choice with the knob.
The functions F1 – F4 can be accessed with the 4 left
side buttons on the Mobile Station. The top button
is for function F1. However, the activated functions
cannot be shown in the display.
14
8036231921.indd 14
Programming with the Märklin*
Mobile Station
The knob must be set to 0.
Press the ESC button.
Turn the knob to the menu option ("New
Locomotive").
Press the knob.
Turn the knob to the menu option ("Databank").
Press the knob.
Choose one of the two universal numbers with
the knob (we recommend starting with 36330)
Press the knob
Press the ESC button
Move to menu option (Change Locomotive")
with the knob
Press the knob.
Choose menu option ("Address")
Press the knob.
Choose the address of the locomotive
Press the knob.
Press the ESC button
Choose the menu option (Erase Locomotive)
Press the knob
Press the knob again to confirm
25.06.2009 12:36:59