roco BR 120 Bedienungsanleitung Seite 15

Congratulations on the purchase of a LokSound
micro
in Sound micro
micro
prototype. You will soon notice that locomotives
equipped with LokSound micro
centre of attention.
The decoders are basically supplied with the address
setting "03" (both for NMRA/DCC, and also for
Motorola**) and with 14 speed steps. The decoder
switches automatically to 28 or 128 speed steps.
The reset facility is convenient: You can call up the
original factory values again at any time both in
DCC and in Motorola** operation. To do this write an
8 in CV 8 or an 08 in Register 08 (see „Possible
settings in DCC digital operation" CV 8 or "Possi-
ble settings in Motorola** digital operation", ).
Please note the following warnings:
• Under no circumstances is a LokSound micro
• LokSound micro
• Avoid jolts and exerting pressure on the decoder
• The decoder installed in your ROCO locomotive has
• Always disconnect the power supply to the decod-
• Should it be necessary to remove the loudspeaker
Multi-protocol operation:
The Sound micro
matically recognizes both the widely used Märklin*/
Motorola** format and also the NMRA/DCC system
based format.
 Can run on direct current (DC) analogue (sound
 is load-regulated: in digital operation the speed
 Recognises braking sections from Rocco as well
Preset address:
8036231921.indd 9
Introduction
®
-Decoders or a ROCO Locomotive with built-
® -Decoder. At last with LokSound
®
your locomotives will sound just like the
decoder to be operated on an analogue alternat-
ing current!
with model railways.
and do not expose it to moisture.
been specifically adapted for this locomotive and
must be used only in this particular locomotive.
er before doing any work on it.
for maintenance work, handle the loudspeaker
extremely carefully: do not put any pressure on
it and do not touch the grey-black loudspeaker
membrane.
Characteristics of the LokSound
micro
®
-Decoder understands and auto-
The decoder
possible)
is maintained at the same regulator setting up
and down grade and with different train loads,
as systems from Zima, Lenz, and Märklin*
® are always the
® -Decoders may only be used
® -Decoder
DCC/NMRA: 03
Motorola**: 03
GB
®
9
25.06.2009 12:36:59