AXXAIR SAXX-200 Originalbetriebsanleitung Seite 70

INNOVATIVE ORBITAL SOLUTIONS
Operator dynamic :
Welding end:
Return to starting position:
Join experience
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
Choose on the left the parameter you
want to modify. Then press + or – buttons
to modify the value.
On the bottom left, you can see the
maximum percentage allowed of the
programmed value.
If the wire speed is displayed and your
machine has left and right buttons, then
the left button act as a push on the button
- and pressing the right button act as a
press on the + button for the wire speed.
Pressing the STOP
downslope causes rapid downslope in 2s.
When cycle is finished, you can to choose
to return at the starting position (this is
done automatically with closed head,
except if there is an alarm). With SATO,
you can use machine buttons: Y for yes
and N for no.
330B Route de Portes Les Valence - ZI Les Bosses - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - Fax: +33 475 575 080 - commerce@axxair.com - www.axxair.com
- 70 -
English
button during