Emptying The Bin; Switching Off The Device - Hama HOME S7 Bedienungsanleitung

g
4.2.2 Shred paper and plastic cards
■ Insert the paper or the plastic card into the centre of the feed shaft
(4). The cutting rollers are switched on automatically.
■ Let go of the paper or plastic card. The device switches back to
standby mode after shredding is completed.
NOTE!
►
4.2.3 Reverse run mode
NOTE!
►
■ Slide the operating switch (2) to the "Rev" position. The rollers of
the paper cutting system rotate in the opposite direction.
■ Pull the paper up and out of the feed shaft (4).
■ To return the device to standby mode, set the operating switch (2)
back to ON/AUTO.

4.2.4 Emptying the bin

■ To switch the device off, slide the operating switch (2) to the "Off"
position.
■ Lift the cutting attachment off of the waste bin (1).
■ Empty the bin.
■ Place the cutting attachment back onto the waste bin (1).

4.2.5 Switching off the device

■ Slide the operating switch (2) to the "Off" position.
10
Empty the bin frequently in order to prevent damage to the
device.
These modes serve to remove any blockages in the cutter
system.
Home S7