Unpacking And Assembling; Unpacking; Assembly - Dirt Devil M7110 Bedienungsanleitung

02_M7110_gb.book Seite 25 Freitag, 10. Oktober 2008 10:17 10

2 Unpacking and assembling

2 Unpacking and assembling

2.1 Unpacking

2.2 Assembly

2
3
4
1. Unpack the appliance and all its accessories.
2. Check the contents for completeness and possible
damages. Information regarding scope of delivery
Page 20, "Overview".
ATTENTION:
Always transport or ship the appliance in its original
packaging to avoid damage. Keep the packaging for
such an event.
Dispose of no longer needed packaging material
according to the applicable regulations of your country.
NOTE:
Immediately contact your dealer if you have found
damage resulting from transportation.
WARNING:
Danger of injury! Only assemble the appliance if it is not
connected to the power supply. Otherwise the machine
might start up and parts of your body, hair or pieces of
clothing might be sucked in.
1. Insert the end of the suction hose into the intake
opening (Fig. 2) of the cylinder vacuum cleaner until it
locks with an audible click.
2. Insert the handle (Fig. 3/1) into the upper end of the
telescopic tube (Fig. 3/2).
3. Attach the floor nozzle (Fig. 3/3) to the bottom end of
the telescopic tube (Fig. 3/4).
4. Adjust the length of the telescopic tube. Press down the
release latch on the tube (Fig. 4) to do this. Then pull
the handle of the telescopic tube to extend (Fig. 3/1) it
to your desired length. Let go of the release catch while
pulling until it locks in place. You will hear a distinct
click.
Your cylinder vacuum cleaner is now ready for use.
25