Putting The Speakers In The Final Location; Attaching The Rubber Feet - Bose 251 Bedienungsanleitung

Making the connections (cont.)
Figures 18A and 18B
Putting the speaker in the final
position
A. Exterior of the house
B. Deck railing or table
Figure 19

Attaching the rubber feet

Figure 20
Rotating the Bose logo

Putting the speakers in the final location

Loosen the knobs on each speaker to rotate the speakers into the desired position. Then,
tighten the knobs to secure the speaker in its final position (Figures 18A and 18B).
A.
Attaching the rubber feet
If you do not plan to use the supplied brackets to mount your 251 environmental speakers, you
can place them on a sturdy, level surface. They should be standing in the vertical position. Be
sure to attach the rubber feet before using your speakers. For proper balance be sure to place
the feet in the position shown in Figure 19.
Rotating the Bose logo
Mounting the speakers on a deck railing or table will require you to rotate the Bose logo. Using
your fingers, gently lift the logo, taking care not to detach it from the speaker, about
cm) and turn it 180º.
Installing Your 251
B.
Speakers
TM
⁄ inch (.24
1
4
11