Maintenance And Repairs - Fein KBM 65 QF Handbuch

3 41 01 018 06 7 - Buch Seite 17 Dienstag, 16. März 2004 7:47 07
KBM 65 Q / KBM 65 QF

Maintenance and repairs.

!
Risk of injury
Service, testing and repairs may only be car-
ried out by electrical engineers in conformity
with the regulations valid in the respective
country.
Maintenance and repairs.
We recommend our customer service
department (repair centre), FEIN author-
ised service centres and agencies.
Addresses can be found at the end of
these operating instructions and in the
enclosed safety instructions.
Please hand these operating instructions
to the repair centre. An overview of spare
parts can be found at the end of these
operating instructions.
Only use original FEIN spare parts.
Spare parts.
The overview of spare parts is at the end
of these operating instructions. Quoting
the parts no. (1), reference no. (2) as well
as the number of spare parts (3) facilitates
the ordering procedure.
Accessories.
Illustrations and reference numbers can be
found at the end of these instructions.
Description of the accessories:
A HM core drill bit with Quick IN adap-
tor, effective length 35 mm.
B HM core drill bit with thread
M 18 x 6 P 1.5, effective length
50 mm.
C HM core drill bit "S" with thread
M 18 x 6 P 1.5, effective length
50 mm.
D FEIN HSS Dura core drill bit with
Quick IN adaptor, effective length
35 mm (titanium-aluminium-nitrite
coat).
E FEIN HSS core drill bit with Quick IN
adaptor, effective length 35 mm.
F Tapping unit.
G Tapping inserts without safety clutch
for tapping drills in accordance with
DIN 376.
H Tapping inserts with safety clutch for
tapping drills in accordance with
DIN 376.
I Adaptor for Quick IN attachment
output M 18 x 6 P 1.5.
J Adaptor for Quick IN attachment
output Weldon.
K Adaptor for Quick IN attachment
output Weldon Spezial.
L Adaptor for Quick IN attachment
output 1/2".
M Adaptor for Quick IN attachment
output B 16.
N Centring pin.
O Reducing sleeve for Morse taper arbor,
holder MT 3/MT 2.
P Quick-action drill chuck, pointed (R)
with cone B 16.
Q Drill chuck cone, holder MT 3/B 16.
R Suction plate for anti-magnetic
materials.
S Vacuum plate for anti-magnetic mate-
rials (vacuum pump is required).
T Vacuum pump.
U Pipe drilling device
(metal plate with strap).
V Hand pump.
W Quick IN attachment shafts.
X MT 3 – for retrofitting.
EN
17