Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Safety Precautions
This product complies with the requirements of the following European
Community Directives: 2004/108/EC (Electromagnetic Compatibility) and
2006/95/EC (Low Voltage) as amended by 2004/22/EC (CE-Marking).
To ensure safe operation of the equipment and eliminate the danger of
serious injury due to short-circuits (arcing), the following safety precautions
must be observed.
Damages resulting from failure to observe these safety precautions are
exempt from any legal claims whatever.
*
Caution! Do not switch-on the unit if the case is dented.
*
Prior to connection of the equipment to the main outlet, check that the
available mains voltage corresponds to the voltage setting of the
equipment.
*
Do not exceed the maximum permissible input ratings (danger of
serious injury and/or destruction of the equipment).
*
Replace a defective fuse only with a fuse of the original rating. Never
short-circuit fuse or fuse holding.
*
Check test leads and probes for faulty insulation or bare wires before
connection to the equipment.
* Use caution when working with voltages above 35V DC or 25V AC.
These Voltages pose shock hazard.
*
To avoid electric shock, do not operate this product in wet or damp
conditions. Conduct measuring works only in dry clothing and rubber
shoes, i. e. on isolating mats.
*
Comply with the warning labels and other info on the equipment.
*
Do not subject the equipment to direct sunlight or extreme
temperatures, humidity or dampness.
*
Do not cover the ventilation slots of the cabinet to ensure that the air is
able to circulate freely inside.
*
Do not insert metal objects into the equipment by way of the ventilation
slots.
*
Do not place water-filled containers on the equipment (danger of short-
circuit in case of knock over the container)
*
Do not subject the equipment to shocks or strong vibrations.
*
Do not operate the equipment near strong magnetic fields (motors,
transformers etc.).
*
Keep hot soldering irons or guns away from the equipment.
*
Allow the equipment to stabilize at room temperature before taking up
measurement (important for exact measurements).
-10-
Werbung
Inhaltsverzeichnis
