Hama 179779 Bedienungsanleitung Seite 13

5.3.1 Turn on the device you want to control
5.3.2 Press the SETUP key until the LED indicator is permanently lit.
5.3.3 Select the device you want to control using the device key (e.g. TV). A
successful selection is indicated by the LED with one flash followed by
permanent light.
5.3.4 Press the PROG+/PROG- keys or POWER to start the Auto Code Search.
The LED indicator flashes once followed by permanent light. The
Universal Remote Control has a latency of 6 seconds before the first
scan starts
Note: Scan Speed Settings
Scan Speed Settings can be set at either 1 or 3 seconds. The default setting
for the scan time per single code is 1 sec. If this feels uncomfortable , you
can switch to 3 sec. scan time per single code. To switch between the scan
times, press PROG+ or PROG- during the 6 sec. latency before Auto Code
Search starts scanning.
5.3.5 The LED indicator confirms each single code scan with a single flash.
5.3.6 Press MUTE(OK) to save the code and exit the code search. The LED
indicator turns off.
5.3.7 To stop the Auto Code Search during the scan process, press the EXIT
key.
Note
When all codes are searched without success, the Universal Remoote
Control exits Auto Code Search and returns to operational mode
automatically. Currently stored code is not changed.
5.4 Code Identification
The Code identification offers you the possibility, to determine an already
entered code.
5.4.1 Press the SETUP key until the LED indicator is permanently lit.
5.4.2 Select the device you want to control using the device key (e.g. TV). A
successful selection is indicated by the LED with one flash followed by
permanent light.
5.4.3 Press SETUP key. The LED indicator flashes once followed by permanent
light.
5.4.4 To find the first digit, press the numeric keys from 0 to 9. The LED
indicator flashes once to indicate the first digit of the 4-digit code
number.
5.4.5 Repeat step 5.4.4 for the second, third and fourth digit.
TV
AUX
CODES
VCR
AMP
SAT
CBL
DVD
DVBT
11