Hama 179779 Bedienungsanleitung Seite 12

5.1 Direct Code Entry
Your Universal Remote Control Package contains a code list. The code list
shows 4-digit codes for most A/V device manufacturers in alphabetical order
and grouped by device type (e.g. TV, DVD, etc.). If the device you want to
control is covered by the code list, the Direct Code Entry is the most convenient
entry method.
5.1.1 Turn on the device you want to control
5.1.2 Press the SETUP key until the LED indicator is permanently lit.
5.1.3 Select the device you want to control using the device key (e.g. TV). A
successful selection is indicated by the LED with one flash followed by
permanent light.
5.1.4 Check code list for brand and type of the device you want to control.
5.1.5 Enter the corresponding 4-digit code using the 0 – 9 keys. The LED
indicator confirms each entered digit via a short flash and turns off after
the fourth digit.
Note
• If the code is valid, it is saved automatically.
• If code is invalid, the LED indicator flashes six times and then turns off.
Repeat steps 5.1.1 to 5.1.5 or use a different code entry method.
5.2 Manual code search
Your Universal Remote Control is equipped with an internal memory, which
is preloaded with up to 350 codes per device type for the most common A/V
devices. You can zap through these codes until the device you want to control
shows a reaction. This might be that the device you want to control switches
off (POWER key) or changes the channel (PROG+/PROG- keys).
5.2.1 Turn on the device you want to control
5.2.2 Press the SETUP key until the LED indicator is permanently lit.
5.2.3 Select the device you want to control using the device key (e.g. TV). A
successful selection is indicated by the LED with one flash followed by
permanent light.
5.2.4 Press the "POWER" or the PROG+/PROG- key to zap through the
preloaded codes until the device you want to control reacts.
5.2.5 Press MUTE(OK) to save the code and exit the code search. The LED
indicator turns off.
Note
Internal memory limitations allow only up to 350 most common device
codes to be preloaded. Due to the extensive number of different
available A/V devices on the market, it may be possible that only the most
common main functions are available. If so, repeat steps 5.2.1 to 5.2.5 to
find a more compatible code. No code may be available for some special
device models.
5.3 Auto Code Search
Auto Code Search uses the same preloaded codes as the Manual Code
Search (5.2) but your Universal Remote Control scanns through the codes
automatically until the device you want to control shows a reaction. This might
be that the device you want to control switches off (POWER key) or changes
the channel (P+/P- keys).
10