Usage For The Intended Purpose - VOLTCRAFT PA 300 Bedienungsanleitung

GB
These operating instructions are an integral part of this pro-
duct. They also contain important instructions on commissio-
ning and handling. Please also take them into consideration
when passing the product on to third parties.
Therefore you must keep these operating instructions for future re-
ference!
The plug-in power supply units were designed on the basis of the
specification VDE 0551 = EN 60742 and/or 61558. Besides, the
plug-in power supply units are EMC-tested and consequently sa-
tisfy the requirements of the applicable European and national di-
rectives. Conformity has been proved; the appropriate documents
(declaration) are kept at the manufacturer's. To make sure this state
is maintained and to ensure safe operation, it is essential that you -
the user - adhere to these operating instructions!

Usage for the intended purpose:

Connection and operation of extra-low voltage consumers with a service
voltage of 3 or 4,5 or 6 or 7,5 or 9 or 12 VDC. The power consumption of
a connected consumer must not exceed 0,3 A for PA 300/PA300 Twist
or 0,5 A for PA 500/PA500 Twist or 0,6 A for PA 600 or 0,8 A for PA 800.
The terminal polarity (+ or - inside) depends on the connection of
one of the enclosed eight (8) plugs (Arrow mark) to the output
(connection)cable.
The plug-in power supply units are only approved for connection to
230 VAC, 50 Hz.
Operation under adverse ambient conditions is not admissible.
- moisture or excessive (air) humidity,
- dust and combustible gases, vapours or solvents
- Thunderstorm or thundery conditions, powerful electromagnetic
fields etc.
7