Disposal; Troubleshooting - Zipper ZI-BTS350 Betriebsanleitung

15.5

Disposal

Do not dispose of your waste in the ZI-BTS350. Contact your local authorities for
information regarding the available disposal options. Improper disposal can lead to
contamination of soil, ground water soil seepage of hazardous and noxious substances,
and thus reach finally through contaminated water into your food supply and your
health. Replace your old unit with a new one at your local dealer, is obligated to take
back your old equipment free of charge for the purpose of proper disposal.
16

TROUBLESHOOTING

Trouble
Engine will not start
Engine stops after starting
Less engine power
Bade does not run
Blade runs bad
ZIPPER MASCHINEN GmbH
ZI-BTS350
Possible Cause
 ON OFF switch to OFF
 Fuel filter clogged
 Great power tank empty
 Spark plug is defective or loose
 Spark plug gap set wrong
 Idle speed too low
 Clogged fuel filter
 The fuel tank is empty
 Dirty air filter
 V-belt is defective
 defective clutch
 cutting wheel shaft
www.Zipper-Maschinen.at
TROUBLESHOOTING
Solution
 Switch in the On position
 Fuel filter change
 Fill the fuel tank
 Clean or replace spark plug

Check the correct setting
 Adjust idle speed
 Change the fuel filter
 add fuel
Clean or replace air filter

 Change belts
 machine repair
 Check ball bearings, shaft,
flange and nut.
 Replace if defective
36