Cameo NANO BEAM 300 Bedienungsanleitung Seite 17

NANO BEAM 300 + NANO WASH 400
-> ENTER ->
<- MODE
MUSIC CONTROL MODE (Sound Mode)
Press the MODE button repeatedly until one of the main menu items appears on the display (Auto Mode, Sound Mode, Slave Mode, Settings,
DMX). Now use the UP and DOWN buttons to select the "Sound Mode" menu item and confirm by pressing ENTER. The Music control mode is now
activated. Press ENTER again to select the desired sensitivity with which the spotlight responds to sounds (00 = minimum sensitivity, 99 = maximum
sensitivity). Confirm with ENTER. After confirming with ENTER, "Saving" appears briefly on the display.
NANO BEAM 300 + NANO WASH 400
-> ENTER ->
<- MODE
SLAVE-MODE (Slave Mode)
Press the MODE button repeatedly until one of the main menu items appears on the display (Auto Mode, Sound Mode, Slave Mode, Settings, DMX).
Now use the UP and DOWN buttons to select the "Slave Mode" menu item and confirm by pressing ENTER. To activate the Slave mode, select "Yes"
using the UP and DOWN buttons, and confirm with ENTER. Connect the slave and the master unit (same model) with a DMX cable and activate one of
the standalone modes on the master unit. Now the slave unit follows the master unit. As soon as you activate a different operating mode, the slave
mode is automatically deactivated (this menu item is set to "No"). After confirming with ENTER, "Saving" appears briefly on the display.
NANO BEAM 300 + NANO WASH 400
-> ENTER ->
<- MODE
SYSTEM SETTINGS (Settings)
To adjust the system settings, press the MODE button repeatedly until one of the main menu items appears on the display (Auto Mode, Sound Mode,
Slave Mode, Settings, DMX). Now use the UP and DOWN buttons to select the "Settings" menu item and confirm by pressing ENTER. Now you can
select one of the following menu items as desired using the UP and DOWN buttons:
NANO BEAM 300 + NANO WASH 400
-> ENTER ->
<- MODE
-> ENTER ->
<- MODE
UP/DOWN
UP/DOWN
UP/DOWN
UP/DOWN
On = Display permanently on
Off = Display switches off after approx.
20 seconds of inactivity
Yes = reversal of the
Tilt movement direction
Yes = reversal of the
Pan movement direction
Using this menu item, you define which
mode is to be activated, should the DMX
input signal be lost in the DMX mode.
-> ENTER ->
UP/DOWN
<- MODE
-> ENTER ->
UP/DOWN
<- MODE
-> ENTER
<- MODE
-> ENTER
<- MODE
-> ENTER ->
UP/DOWN
<- MODE
-> ENTER ->
UP/DOWN
<- MODE
-> ENTER ->
UP/DOWN
<- MODE
-> ENTER ->
UP/DOWN
<- MODE
-> ENTER
<- MODE
(Music control)
(Blackout)
(= last DMX
command is
held)
-> ENTER
<- MODE
-> ENTER
<- MODE
-> ENTER
<- MODE
-> ENTER
<- MODE
-> ENTER
<- MODE
17