Herunterladen Inhalt Inhalt Diese Seite drucken

Babyschale Montieren; Mounting The Infant Carrier - HASE TRETS Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für TRETS:
Inhaltsverzeichnis

Werbung

TRETS

Babyschale montieren

Für Babys im Alter von ca. 1 bis 10 Monaten, die noch nicht
selbst sitzen können und deren Körpergröße 75 cm und Kör-
pergewicht 10 kg nicht überschreitet, ist eine federnde Baby-
schale und Fußablage vorgesehen.
1. Legen Sie die beiden Schlaufen der oberen Befestigungs-
gurte (4) der Babyschale um die Haltestange an der
Rückenlehne des Trets Trike und ziehen Sie die Klemm-
schnallen fest.
2. Lösen Sie die Klemmschnallen an der Vorderseite der
Babyschale (6) und ziehen Sie die Befestigungsgurte aus
der Klemmschnalle (1) heraus.
4. Legen Sie das lose Ende des Bandes von unten um das
Gestell (2) des Fußnetzes und ziehen Sie es durch die
Klemmschnalle (1) wie im Bild gezeigt.
5. Wiederholen Sie dieses mit dem zweiten Befestigungsgurt.
6. Ziehen Sie beide Klemmschnallen so fest, dass die Baby-
schale fest gespannt ist.
Achtung!
Die Babyschale muss straff gespannt sein. Bei Belastung
darf sie nur wenig nachgeben. Bei einer zu lose gespann-
ten Babyschale könnte das Baby in Extremsituationen
herumgeschleudert werden, was zu lebensgefährlichen
Verletzungen führen kann.
7. Stecken Sie die Schultergurte (4) je nach Körpergröße
des Babys, durch die unteren oder durch die oberen
Schlitze in der Babyschale.
8. Stecken Sie den Schrittgurt (5) durch den Schlitz in der
Babyschale.
9. Setzen Sie das Kind bei geöffneten Steckverschlüssen der
Sicherheitsgurte in die Babyschale.
10. Legen Sie beide Schultergurte um die Schulter des
Babys.
11. Führen Sie den Schrittgurt zwischen den Beinchen des
Babys hindurch und stecken Sie die Stecker der Schulter-
gurte (4) in den Verschluss im Schrittgurt (5).
12. Passen Sie anschließend den Sicherheitsgurt an die Kör-
pergröße des Babys an.
Trets 1/12-D-ENG
1
1
2
4
4
4

Mounting the Infant Carrier

For babies between one and 10 months of age who are not
yet able to sit upright unassisted, a suspension Infant Car-
rier (optional accessory) is available. This carrier comes with
a footrest and is suitable for young passengers up to 75 cm
(29½ inches) in height, weighing a maximum of 10 kg (22 lbs).
1. Slide the two loops of the upper mounting straps (4) of
the Infant Carrier over the ends of the child-seat brace
on the seatback of the Trets Trike, and tighten the straps
using the ladder-lock buckles.
2. Unthread the fastening straps from the ladder-lock buck-
les (1) on the front of the Infant Carrier (6).
4. Wrap the loose end of the strap around the frame (2)
of the footrest from below, and feed the strap end back
through the ladder-lock buckle (1) as shown.
5. Repeat with the second attachment strap.
6. Tighten the ladder-lock buckles until the Infant Carrier is
stretched tight.
Caution!
The Infant Carrier must be stretched tight. It should only
yield slightly under pressure. If the Infant Carrier is too
loose, the baby could be tossed around in extreme situa-
tions, which could lead to life-threatening injuries.
7. Thread the shoulder straps (4) through the lower or
upper slots of the Infant Carrier, depending on the size of
the baby.
8. Thread the crotch belt (5) through the slot in the Infant
Carrier.
6
9. Undo the snap buckle, and place the child on the Infant
Carrier.
5
10. Draw the two shoulder straps over the baby's shoulders.
11. With the crotch belt between the baby's legs, insert the
ends of the shoulder straps (4) into the snap buckle on
the crotch belt (5).
12. Then adjust the safety harness to the size of the baby.
Zubehör Jogger-Option
Optional Jogger Kit
25

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Trets trike

Inhaltsverzeichnis