Timer Function; Setting The Timer - Siegenia AEROPAC Originalbetriebsanleitung

Original Operating Instruction

Timer function

The Timer button is used to activate and deactivate the Timer function. When the timer is activated,
the timer starts the unit for a preset run time (in hours). This is preset at the factory to 8 hours. The
blower automatically switches off after the run time has elapsed.
24 hours after the timer has been activated, the unit restarts automatically with the settings that were
last selected. This procedure is repeated cyclically every 24 hours. The function ends when the timer
is switched off.
Note: After a power failure, the timer must be activated again.

Setting the timer

The timer run time may be set to a value between 1 and 18 hours and can be changed at any time.
1. Press the Timer button once (pressing
the button again ends the Timer
function).
2. Set the run time:
-- To shorten the run time, press the
– button immediately.
-- To extend the run time, press the
+ button straight away.
Note: The display lights up briefly, the
clock symbol flashes, and the set blower
level plus the run time in hours are
displayed.
Note: Approx. 5 sec. after the run time has
been set, the display changes to show the
remaining run time.
• Remaining run time: 5:59 hours
(set run time: 6:00 hours)
Last update: 7.2.2014
AEROPAC
40