Aeropac Wave Unit Type: Start-Up - Siegenia AEROPAC Originalbetriebsanleitung

AEROPAC

AEROPAC wave Unit Type: Start-Up

The AEROPAC wave is included in the Z-Wave wireless network
Note: The following documentation for including the AEROPAC wave in the Z-
Wave wireless network is intended exclusively for trained specialists.
Inclusion / Exclusion
Press the on/off button three times within 1.5 seconds.
Including the unit in an existing Z-Wave network
AEROPAC wave is fully Z-Wave-compatible and can be operated together with the Z-Wave com-
ponents of other manufacturers. The unit is a network "listening node" that functions as a repeater
to transmit wireless data. To include the AEROPAC wave, press the button on the unit that is used
for system administration (see the applicable operating instructions for further details). Now press
the on/off button (see above) to include the AEROPAC wave in the Z-Wave network.
Resetting the unit
Press the on/off button three times within 1.5 seconds.
Then press and hold the button for 5 seconds.
One flash of the LED confirms the following actions:
• AEROPAC wave has been included in a Z-Wave network or excluded from a network.
• AEROPAC wave has been reset to the factory settings.
Supported classes
• COMMAND_CLASS_SWITCH_MULTILEVEL
• COMMAND_CLASS_SENSOR_MULTILEVEL_V3 (controlled)
• COMMAND_CLASS_PROTECTION
• COMMAND_CLASS_CONFIGURATION
• COMMAND_CLASS_SWITCH_POWERLEVEL
• COMMAND_CLASS_VERSION
• COMMAND_CLASS_MANUFACTURER_SPECIFIC
BASIC SET/BASIC REPORT/MULTILEVEL SET/MULTILEVEL REPORT
0 = off; 255 = on with previously set blower level
Blower level: 1-16 = 1; 17-32 = 2; 33-48 = 3; 49-64 = 4; 65-80 = 5; 81-96 = 6; 97-99 = max.
37
Original Operating Instruction
Last update: 7.2.2014