Using The Machine; Electrical Connection - BOMANN dbs 760 cb Bedienungsanleitung

Ironing without steam
1. Sort out the garments according to their ironing temperatures.
2. Always turn the temperature control to the lowest temperature setting (before the setting
" ") before connecting the device to or disconnecting it from the mains.
3. Start with the lower temperatures. It is set with the thermostat (1):
• Synthetics, silk
• • Wool
• • • Cotton, linen
MAX
4. Place the iron on its stand.

5. Electrical connection

• Make sure that the iron voltage (see name plate) and the line voltage match.
• Only connect the machine to a properly installed safety socket,
230 V/50 Hz.
6. Turn operating switch I (10) on the station to position 0 and move the steam regulator
(9) to MIN. Please ensure that operating switch II (11) is turned to position I. Operating
switch II (11) lights up.
7. The control lamp of the iron (5) shows it is being heated up. As soon as the control lamp
goes off the operating temperature has been reached. Now you can start ironing.
8. Always remove the mains plug after using the machine.
Steam Ironing
GB
For this a high temperature is needed.
1. Turn the temperature control (1) to position „• • •" (cotton, linen).
2.
Move both operating switches (10/11) to position I. During operation the control lamp
(12) shows whether there is enough steam available for steam operation.
On = enough steam available,
Off = steam being produced
(The control lamp (13) also lights up briefl y).
Warning: The steam is hot! There is a danger of scalding!
You can set the desired quantity of steam with the steam regulator (9).
3.
4. With the steam jet button (2) you can produce a short strong jet of steam. Continuous
steam is produced by locking the catch (3) in place.
48
05-DBS 760 CB 48

Using the Machine

low temperature
medium temperature
high temperature
maximum temperature
22.03.2006, 10:34:46 Uhr