babymoov Ultimate Care Bedienungsanleitung Seite 15

• To minimize the radiations, or when you don't need to see the image on the screen, you can permanently
switch off the camera and only use the audio mode, using the screen On/Off switch (23).
With an optional USB cable, the image on screen can be displayed
on PC. Connect one end of cable to the USB port (15) on parent unit
and other end to PC. The screen of parent unit will become dark
while the image can be seen on PC.
NB : the baby sound cannot be heard in PC but only in parent
unit's speaker.
A/ Transmitter
Using the supplied mounting fixture, the baby unit can be mounted on handrail of baby cot.
1. Insert protruding stud on fixture into the catch located at the back of baby unit.
2. Mount the fixture over the handrail of baby cot.
3. Screw in the spiral rod clockwise until the tip of rod touches the back of baby unit. This will prevent the
baby unit from sliding out.
B/ Receiver
The parent unit can be carried around using the swivel belt clip (25). It can also be turned 180º to support
the unit to stand alone on a flat surface for better viewing.
a. 6V switching power supply for baby unit
b. 5V switching power supply for parent unit
c. Transmitter
d. Receiver
e. Rechargeable 1 500 mAh Li-ion battery pack
(installed in parent unit)
f. Mounting fixture
g. Instruction manual
PC CONNECTION
FIXATION SYSTEMS
ACCESSORIES
c
BABY MONITOR ULTIMATE CARE • Instruction Manual
a
e
d
Tip of spiral should
touch back side if baby
unit.
Turn clockwise to
lock.
b
f
g
17