Before Starting The Equipment - EINHELL TH-SP 204 Originalbetriebsanleitung

Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
•
Important! Pull out the power plug before
performing any maintenance, cleaning and
adjusting work.
•
Check at regular intervals that the knife (21)
and latch (22) are firmly attached in the knife
block (23). (Fig. 17)
•
The knives (21) must not project more than
a maximum of 1.1 mm out of the knife block
(23). (Fig. 17)
•
Never remove the safety covers on the machi-
ne except for servicing and repair work.
•
The safety covers must be intact at all times.
Each time you use the machine, first fasten
and secure the safety covers at the points
provided.
•
Connect a dust extractor to the sawdust
extractor (5) if you use the machine in an enc-
losed area.
•
Make sure that the anti-kick claws (24) work
correctly. (Fig. 15)
•
Always wear eye protection.
•
Never cut concavities, tenons or shapes.
•
Unpack the surfacing and thicknessing plane
Anl_TH_SP_204_SPK7.indb 22 Anl_TH_SP_204_SPK7.indb 22
GB
and examine it for any transit damage.
•
The machine has to be set up and aligned
where it can stand securely.
•
All covers and safety devices have to be pro-
perly fitted before the machine is switched on.
•
It must be possible for the planing knife to run
freely.
•
When working with wood that has been pro-
cessed before, watch out for foreign bodies
such as nails or screws, etc.
•
Before you press the ON/OFF switch (1),
make sure that the planing knife is fitted cor-
rectly and that the machine's moving parts
run smoothly.
6. Assembly
6.1 Parallel stop (Figure 4/5)
•
Place the mount (25) against the feed table
(13).
•
Make sure that the holes in the mount (25)
line up with the female threads in the feed
table (13).
•
Secure the mount (25) to the feed table (13)
using the two Allen screws supplied.
6.2 Planing knife cover (Figure 1-3)
•
Place the holder for the planing knife cover
(8) on the left-hand side of the planing table
(14) so that the pin and grub screw engage in
the two holes.
•
Secure the planing knife cover (12) using the
locking knob (33) supplied
6.3 Rubber feet/tipping guard bar (Figure 1-2)
Secure the four rubber feet (11) to the bottom
side of the equipment using the Allen screws (37)
and washers (36) supplied.
- 22 -
28.03.13 12:47 28.03.13 12:47