Technical Data; Before Starting The Equipment - EINHELL 43.452.61 Originalbetriebsanleitung

Anleitung_BT_PL_750_SPK1:_

4. Technical data

Mains voltage: 230 V ~ 50 Hz
Power input:
Idling speed: 16,500 min
Chip depth:
Rebate depth:
Plane width:
Protection class:
Weight:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level 87,5 dB(A)
pA
K uncertainty
pA
L sound power level 98,5 dB(A)
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Vibration emission value a = 4,189 m/s 2
h
K uncertainty = 1,5 m/s 2
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
17.11.2010 10:50 Uhr
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
750 W Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
-1
Do not overload the appliance.
0-2 mm
Have the appliance serviced whenever
0-6 mm necessary.
Switch the appliance off when it is not in use.
82 mm
Wear protective gloves.
II / ®
Residual risks
2.9 kg
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3 dB
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
3 dB

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
5.1 Adjusting the chip depth (Fig. 4/Item 1)
You can adjust the chip depth in steps of 0.1 mm
from 0 to 2 mm by turning the setting knob for the
chip depth (1).
Turn the setting knob for the chip depth (1) in a
clockwise direction to set a greater chip depth.
Greater chip depth
Turn the setting knob for the chip depth (1) in a
counter-clockwise direction to set a lower chip depth.
Lower chip depth
After finishing work, set the chip depth so that the
knives are lowered and thus protected from damage.
Turn the setting knob for the chip depth to position
"0" for this purpose.
Seite 13
GB
13