Inhaltsverzeichnis
Werbung
3. Water leaking from the pump
• Seals worn out
• Check and replace, or refer to dealer
4. The motor stops suddenly
• T hermal safety switch has tripped due to
overheating.
• C heck that the mains voltage corresponds
to specifications. An extension cable,
which is too thin, and tool long can cause
a voltage drop and cause the motor to
overheat. Leave to cool down. Use heavy
duty extension cables.
5. The pump does not reach the necessary
pressure.
• Water inlet, filter is clogged
• Clean the water inlet filter
• Pump sucking air from connections or hoses
• Check that all supply connections are tight
• S uction/ delivery valves are clogged or worn
out.
• C heck that the water feeding hose is not
leaking.
• Unloader valve is stuck
• Clear or respire valves
• Lance nozzle incorrect or worn out
• L oosen and re-tighten regulation screw
Check and/ or replace.
Repairs and servicing should only be
carried out by a qualified technician or
service firm.
Cleaning
Keep the ventilation slots of the machine clean to
prevent overheating of the engine.
Clean the housing regularly with a soft cloth,
preferably every time it is used.
Keep the air vents free of dust and dirt. Remove
stubborn dirt with a soft rag moistened in soapy
water. Do not use any solvents such as petrol,
alcohol, ammonia, etc. as such substances can
damage the plastic parts.
Lubrication
The appliance does not need any extra
lubrication.
8
Storage and transportation
Keep the high pressure washer in well-ventilated
dry premises with temperature not going below
+5ºC. Operate the cleaner with non-corrosive/
non-toxic antifreeze before storing for the winter.
faults
If a fault arises through wear in an element,
please contact the service address shown on the
warranty card. A drawing of the spare parts that
may be obtained is included at the end of these
operating instructions.
ENvIRoNMENT
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
Damaged and/or disposed of electrical or
electronic devices must be dropped off
at recycling stations intended for that
purpose.
only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EC for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
The product and the user manual are subject to
change.
Specifications can be changed without further
notice.
WARRANTy
Read the terms of warranty on the separate
warranty card which is enclosed.
Werbung
Inhaltsverzeichnis
