Schumacher PBI2212 Bedienungsanleitung Seite 56

PBI4424
Internal Battery Type
Output Voltage
Cranking Amps
Rated Capacity
Application Range
DC Power Outlet (Max. Continuous Load) 12V DC/15A
Booster Cables
Dimensions (H x W x D)
Product Weight
3 Pin Charger Input
13. REPLACEMENT PARTS FOR THE BOOSTER
Battery Clamp Jaw Replacement Kit ............................................................ 2299001580
Charger (EU) ...................................................................................................94065011C
Charger (UK) ...................................................................................................94065011G
Charger (Australia) ............................................................................................94065011I
Fuse (300A) ...................................................................................................3999002113
Fuse (500A) ...................................................................................................3999002114
13.1 Battery Clamp Replacement
1. Make sure the rotary switch on the front panel is in the OFF (O) position and the
booster charger is not connected.
2. Secure the clamp in the open position using a vise or equivalent clamping device.
WARNING: The clamps are spring loaded, so use caution when replacing the jaws to
avoid injury.
3. Remove the rear screw that attaches the booster cable to the jaw.
4. Remove the screw holding the copper jaw to the plastic clamp. Repeat for other jaw.
5. Remove the two jaws and braided cable.
6. Reverse the steps to install the replacement parts.
Maintenance-free AGM lead-acid
12V DC/6 cells; 24V DC/12 cells
480 Amps (12V), 300Amps (24V)
(2) 16 Ah
12V DC/6 cells; 24V DC/12 cells (20 Ah – 200 Ah)
33.61 mm ga, 139.7 cm long
2
38 x 35.6 x 19.6 cm
16.90 kg
12V DC/2A
56
• •