SUNWARE FOX-350 Bedienungsanleitung Seite 42

6.2
After switching the battery output manually, the
charge controller retains this manual setting for a
maximum of 12h. Then the battery output is
switched back to automatic control.
Three other parameter menus are available to set
the system voltage, the maximum charging voltage,
and the cutoff voltage of the deep discharge
protection. These settings are saved permanently
and remain stored even after an operating voltage
cut.
Pressing the "Esc" key automatically takes you back
to the default menu.
77
Detailed technical description
6.2
Silicone keyboard for comfortable operation
The following settings can be made via the keyboard:
1.) Selecting the required display mode by pressing
the Display/Enter key.
2.) The Select keys (arrow keys) allow you to make
manual settings.
3.) The "Esc" key takes you back to your selected
default display or to the starting menu. In
addition, the display is updated.
Manual switching of load output:
In order to switch the load output manually, press the
Display/Enter key until you see the following menu:
"Switch Load < ON >".
The load output is switched off by pressing the left
Select key (down arrow) once - the display now
shows "Switch Load < OFF >" - and confirming it with
the Display/Enter key. The display now briefly shows
"Saved" to signal that the change has been accepted,
before switching back to the default display.
Detailed technical description
E
78