Master Lock MLD08EB Gebrauchsanweisung Seite 4

With a Secondary User's Fingerprints
(select models only- 2 fingerprints can be programmed per user)
1
2
3
4
When enough valid scans have been done (between 5-10 scans) the LED light will flash green
three times. There is a slight delay before the fingerprints are enrolled and the LED flashes
green 3 times.
5
After enrolling your first finger, immediately swipe your second finger across the fingerprint
scanner. You will need to swipe this finger multiple times. The LED light will flash green once
for each valid scan.
6
When enough valid scans have been done (between 5-10 scans) the LED light will flash green
three times.
To Remove a Primary User's Fingerprints
1
Press and hold the button until the keypad flashes 3 times. The LEDs will remain on to indicate
it is ready.
2
Swipe a finger across the fingerprint scanner only once, then wait 10 seconds. The red LED will
flash 3 times to indicate the primary user's fingerprints have been erased.
To Remove a Secondary User's Fingerprints
1
Press and hold the button until the keypad flashes 3 times.
2
Press and hold the button until the keypad flashes 3 times. The LEDs will remain on to indicate
it is ready.
3
Swipe a finger across the fingerprint scanner only once, then wait 10 seconds. The red LED will
flash 3 times to indicate the primary user's fingerprints have been erased.
NOTE:
• The user code or fingerprint programmed will not be erased when the battery power is
removed.
• If you program a four or five digit user code , you will need to wait 10 seconds until your
code is accepted. This is only valid during the setup of your safe. If you program a six digit
user code, then the light will immediately turn green.
Press and hold the reset button until the keypad flashes 3 times.
Press and hold the reset button again until the keypad flashes 3
times. The LEDs remain on to indicate is now ready to accept a new
secondary user fingerprint.
Swipe first finger across fingerprint scanner. You will need to swipe
this finger multiple times. The LED light will flash green once for each
valid scan.
4