3M X31 Benutzerhandbuch Seite 114

Communicaion Port
The following two ports are assigned for the command control.
Port Settings
Network Control
Port1 (Port: 23)
Network Control
Port2 (Port: 9715)
When the authentication setting is enabled, the following settings are required.
Security Settings
Network Control
12
Port open
Control Port1 (Port: 23)]
[Authentication] setting when authentication
Authentication
is required.
Control Port2 (Port: 9715)]
Port open
[Authentication] setting when authentication
Authentication
is required.
Authentication
Enter the desired authentication password.
Password
This setting will be the same for [Network
Control Port1 (Port: 23)] and [Network
Authentication Control Port2 (Port: 9715)].
Password
3M™ Digital Projector X31/X36/X46
Command Control via the Network
[Enable] check box to open [Network
[Enable] check box for the
[Enable] check box to open [Network
[Enable] check box for the
© 3M 2010. All Rights Reserved.