Scale Configuration - KERN YKT-01 Bedienungsanleitung

Appendix D

Scale configuration

This additional description contains information on the required settings to be made on the
scales in order to enable a communication between scale and printer. Where a scale type is
selected under
INTERFACE
corresponding data regarding bits per second, data bits, parity, stop bits and reports. At the
printer end all settings for a successful data communication between scale and printer have
therefore already been made. Only the parameters of the scale software will need to be adjusted.
The following settings should be made (with reference to the model specific operating manual):
Model 470
i F.2
81 o.c.3
82 b.L.1
83 PA 0 (setting does not appear with
all devices)
Models 572/440/DE/KB/CB
9600 baud
"Autoprint" and "Autoprint PC" off
Numerator must be switched off
Models 822/824/870/880
9600 baud
Par E
Print ST (single printout of a stable value)
Per-ALL off (printout of weighing result only)
Prt-dEL off (no print delay)
GLP off
Models PRS/PRJ
9600 baud
7 bit
Par E
1 stop bit
ITx/FTx
Model
2700 baud
7 bit
Par Even
1 stop bit
the printer automatically accepts the
INTERFACE PARAMETERS
Model 474
6 IF 1
61 o.c.3
62 b.L.1
7 un.1
Models 770/GS/GJ/CGB
514 612
523 622
531 641
542 721
Models EW/EG
6 0. c.3
7 b.L.1
Models ABS/ABJ
1200 baud
8 bit
Par N
1 stop bit
with all
73