Tolerance Display/Changing Tolerance Value (Tol); Displaying Tolerance; Inputting The Tolerance - KERN YKT-01 Bedienungsanleitung

5.3

Tolerance display/changing tolerance value (TOL)

5.3.1 Displaying tolerance

short pressing: Current tolerances will appear in the display.
TOL
The cursor will appear on the sign of the Upper Tolerance.
O . T o l
U . T o l
Attention:
The input or changing of a tolerance value is only possible when the measuring series is
deleted with the AC key. Within a series of measurements, tolerance values are only shown
on the display, manifested by the absence of a flashing cursor.

5.3.2 Inputting the tolerance

With keys can the selected position be edited
With keys the selected position be can edited. Valid entries are the
▲ ▲ ▲ ▲ ▲
▼ ▼ ▼ ▼ ▼
numbers 0 to 9 and the signs " + ", " - " and " . "
Note:
- The default value is zero.
- The maximim number of positions including sign and decimal point is 10.
- This may only include 6 digits after the decimal point.
- It is permissable to enter any character of your choice in the 10 available positions.
- Positions remaining vacant between the numerals will be filled in during saving by
moving them to the right.
- After saving, the numerals will be right aligned
With key the character where the flashing cursor is positoned can be deleted.
C
AC
With can the whole figure be deleted and the cursor will return to the input field.
ENTER
With key it is possible to alternate between the upper and lower tolerance
values.
With TOL is the input of tolerance value concluded, the tolerance value is saved
and the input menu can be exited.
± 1 0 0 . 0 0 0 0
+ 9 9 . 5 0 0 0
51