Electrical Connection; Mounting The Carbon Filter - KKT KOLBE CUBE Benutzerhandbücher

Installation
1) Position the hanging plate on the ceiling
and mark the position of the holes before
drilling.
Attention:
Use anchors and screws according to the
property of the ceiling on which you want
to install the plate. Ask an electrician or
qualified engineer/technican to select
anchor bolt or screws. (4mm diameter)
2) Assemble the decorative planel with the
hanging plate - with screws 2 x ST4 *8mm.
3) Slightly press the tips on the plate cable
holders and insert the cables directly.
These will be blocked automatically.
Adjust the length depending your individu-
al requirements.
Note: The cables can only be adjusted
when the cable holder tips are pressed.
4) Lift the hood (at least two persons) and
connect the hood with the hanging plate
using four cables. Insert the cables to the
cable holders which are placed on top of
the cooker hood. Adjust the cable length.
Original Carbon filter
for this model: K606

7.2 Electrical connection

Before connecting the extractor hood,
check that the voltage stated on the rating
plate (V) agrees with the supply voltage in
your home.
Never install the appliance if the data on
the rating plate does not agree with your
supply voltage. You will find the rating pla-
te inside the appliance, behind the grease
filter. If the extractor hood is fitted with a
standard connector plug, connect this to
an easily accessible standard socket.
If the appliance is not fitted with a connector
plug, a two-pole switch, conforming to stan-
dards with a minimum open contact gap of
3 mm is to be installed by an authorized tra-
desman in an easily accessible location.

7.3 Mounting the carbon filter

You will find the mounting instructions
for the carbon filter in its packaging. To
mount the carbon filter, remove the gre-
ase filter(s), fit the carbon filter according
to its mounting instructions and refit the
grease filter(s).
31 31