Use As A Circulation Hood; Mounting The Carbon Filter; Electrical Connection - KKT KOLBE CUBE Benutzerhandbuch

Installation
• Lift the cooker hood upwards (at
least two people are recommended).
Attach the ropes to the brackets provi-
ded on the top of the cooker hood.
Note:
Adjust the rope length to your indivi-
dual needs beforehand.

9.4 Use as a circulation hood

This appliance is factory-provided for
circulation. For this check inside the
hood that the carbon filters are attached
on the right and left of the motor unit.

9.5 Mounting the carbon filter

• Remove the metal grease filter.
• The carbon filter is mounted in two
parts to the right and left of the motor.
Check whether the teeth correspond
to the direction of the rotation of the
respective side.
• Turn the activated carbon filter onto
the motor housing (usually clockwise).
• Reinsert the metal filter.
(Abbildungen können abweichen)

9.6 Electrical connection

!
Only connect the appliance to the po-
wer supply once it is properly installed.
Never install the appliance if the data
on the rating plate (V) does not agree
with your supply voltage.
You will find the rating plate inside the
appliance, behind the grease filter.
If the extractor hood is fitted with a
standard connector plug, connect this
to an easily accessible standard socket.
If the appliance is not fitted with a con-
nector plug, a two-pole switch, confor-
ming to standards with a minimum open
contact gap of 3 mm is to be installed by
an authorized tradesman in an easily ac-
cessible location.
37