Connection Of Sensors; Programming - IFM Electronic ecomat200 DA 340 Betriebsanleitung

Connection of sensors (24 V DC):
range 0 - 1 V
3
5
0-1 V
6
0-xx V
R x
To guarantee safe functioning, signal cables and load cables should be laid sepa-
rately. Use screened cable if necessary.

5. Programming

Changeover to the
1
programming mode
Selection
of the
2
parameter to
be changed
Setting of
3
parameter
If no button is pressed any more, the unit will return to the operating mode after 8s. The changed
*Setting step by step by pressing the button once or continuously by pressing it permanently.
Quick run: pressing the
**Active termination of the programming mode: Select parameter P85, enter value 1 and
acknowledge with the
Locking/unlocking
The unit can be locked to prevent unwanted adjustment of the set parameters.
Select parameter P00, enter value 1 and acknowledge with the
For unlocking:
- Press the button for a short time.
P
- Now press the
range 0 - 10 V
0-10 V
freely definable voltage range 0 - xx V
The maximum value of the voltage range can be assigned by an
3
external resistor between terminals 8 and 6.
5
Calculation of the resistance value:
8
R [kΩ Ω ] = (U [V] x 25) - 25
6
U = 120 V!
max
P
Press the button for a short time.
Press the or
Press the
Press the
Press the button.
parameter values will become active.**
P
(or ) and buttons once at the same time.
button.
, and buttons one after the other within 5s.
P
range 0/4 - 20 mA
3
5
0/4-20mA
7
button until the requested parameter is shown
in the display.*
button. The current parameter value is shown
in the display.
or button until the requested parameter value
is shown in the display. *
The next parameter is shown in the display.
Continue with step 2.
will be shown in the display.
DA 340
DIGITAL DISPLAY
range 4 - 20 mA
3
5
4-20mA
6
9
is shown in the display.
button.
5
6
9
13