Herunterladen Inhalt Inhalt Diese Seite drucken

Daikin FWT02CATNMV1 Installationshandbuch Seite 7

Vorschau ausblenden Andere Handbücher für FWT02CATNMV1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 13
Mounting Installation Plate
Ensure that the wall is strong enough to withstand the weight
of the unit. Otherwise, it is necessary to reinforce the wall
with plates, beams or pillars.
Use the level gauge for horizontal mounting, and fix it with
5 suitable screws for FWT02/03/04 and 7 suitable screws for
FWT05/06.
In case the rear piping draws out, drill a hole 65mm in
diameter with a cone drill, slightly lower on the outside wall
(see figure).
FWT02/03/04
Mounting plate
fi xing screw
FWT05/06
Mounting plate
fixing screw
Recommended Mounting Plate Retention Spots And
Dimensions
FWT02/03/04
Recommended mounting
plate retention spots
(5 spots in all)
166
54.5
153.8
263
51.9
800
Water outlet
Water inlet
FWT05/06
Recommended mounting plate
retention spots (7 spots in all)
190
Water inlet
45
91
Water outlet
45
580
1065
Mounting plate
Mounting plate
Use tape measure as shown.
Position the end of a tape
measure at
184
Through the
wall hole
Ø 65mm
181.7
55.5
Drain hose
position
All dimensions are in mm
173
Through the
wall hole
Ø 65mm
Drain hose
219
48
position
All dimensions are in mm
Hole with cone drill
Inside
Wall embedded pipe
(Field supply)
Wall hole cover
(Field supply)
Mount The Unit Onto The Installation Plate
Hook the indoor unit onto the upper portion of the installation
plate (Engage the two hooks at the rear top of the indoor unit
with the upper edge of the installation plate). Ensure that the
hooks are properly seated on the installation plate by moving
it to the left and right.
How To Attach The Indoor Unit
Hook the claws of the bottom frame to the mounting plate.
How To Remove The Indoor Unit
Push up the marked area (at the lower part of the front grille)
to release the claws.
Front grille
Hang indoor unit's hook here.
When stripping the
ends of interconnecting
wires in advance, bind
right ends of wires with
insulating tape.
Wire guide
Water Drainage Piping
The indoor drain pipe must be in a downward gradient for
smooth drainage. Avoid situations that are likely to cause
water to leak.
Water Drainage
Water
Water
leaking
leaking
Correct
Wrong
1-5
Outside
Caulking
Ø 65
Wall embedded pipe
(Field supply)
Mounting plate
Clip
Bottom frame
Mark (rear side)
Mounting plate
Interconnecting
wires
Water
Retention
End dipped
Water
into water
leaking
Drain
Wrong
Wrong

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis