Dometic MS880 Montage- Und Bedienungsanleitung Seite 36

Synchronising with an analogue connection
If the cruise control does not take on the speed gently or the save value is not
applied:
➤ Press the SET button again to increase the value or
➤ ... press the RES button to decrease the value.
✓ You will hear a signal each time you press the button.
The current value is indicated by the number of beeps (3 – 14 beeps). The factory
setting is 5 beeps.
➤ Apply the brake to save the set values (PPM and GAIN).
✓ Normally, your cruise control should be ideally preset for your vehicle.
➤ Quit setup mode (chapter "Quitting setup mode" on page 36).
➤ You can now use MagicSpeed MS880.
I
NOTE
If, during operation, you notice that the vehicle reacts too slowly or too
suddenly, or the speed is not being regulated correctly, you must set the
control sensitivity manually (see "Setting the control sensitivity (GAIN
mode)" in the diagnostics manual on our homepage).
12.6 Quitting setup mode
To quit setup mode, proceed as follows:
➤ Stop the vehicle.
➤ Apply the brake and hold it down.
➤ Press the SET button four times.
✓ You will hear a long signal.
✓ You have now quit setup mode.
36
MS880
EN