Dometic MS880 Montage- Und Bedienungsanleitung Seite 28

Synchronising with a CAN-bus connection
Step 2 (accelerator pedal test)
➤ Press the accelerator pedal slowly as far as it will go and let it return the same way
slowly as far as the neutral position.
✓ While this happens,you will hear acoustic signals which signify the various
positions:
– Neutral position (idle):
– 50 % position:
– 100 % position:
I
NOTE
• If a low-pitched signal does not sound or you hear a high-pitched
signal during the pedal test, this step has failed and programming
must be repeated from step 1.
• Some accelerator pedals do not provide sufficient electric signals
when fully pressed down. In this case, only press the pedal approx.
three-quarters of the way down in step 2, as otherwise the test will
not be successful.
Step 3 (quit synchronisation)
➤ Switch the ignition off.
✓ Normally, your cruise control should be ideally preset for your vehicle.
Refer to the figure on page 29 for a summary of the CAN bus connection and pedal
test.
28
...
...
...
MS880
EN