Programming Additional Transmitters - Becker Centronic EasyControl EC142-II Montage- Und Betriebsanleitung

a) Readying the receiver for programming
• Switch off the receiver power for 5 seconds, then switch it back on.
or
• Activate the programming button or the radio switch on the receiver.
The receiver is now in programming mode for 3 minutes.
b) Programming the master transmitter
While in programming mode, press the programming button on the master transmitter
until the receiver confirms that the programming has been successfully completed.
The programming process is now complete.

2) Programming additional transmitters

a) Press the programming button of the master transmitter until the receiver confirms.
b) Press the programming button of the new transmitter until the receiver confirms.
c) Now re-press the programming button of the new transmitter you wish to
programme.
The receiver will confirm that the programming has been successfully completed.
The maximum radio range on and in the building is 15 m and in the open 150 m.
de
en
fr
nl
29