Use And Operation - Klarstein 10006586 Handbuch

Wall Mounting
1. Connect the appliance to safety socket (with earth pin connection).
2. Turn on switch to the heating position.
Model
I
II
I+II
3. Turn the thermostat knob in the direction of clockwise until reaching the maximum temperature.
4. Once the room temperature is reached, slowly turn the thermostat knob in the direction of anticlockwise
until you hear a click and then the heater will stop working.
5. The heater will turn on and off automatically to maintain the room temperature you have set.
6. Turn off the switches to stop working. Unplug the appliance then after.
9

Use and Operation

10006586 10006587
750 W 750 W
1250 W 1250 W
2000 W 2000 W
The device must be installed so that airflow is
not obstructed. The installation must be done by
the service agent or similarly qualified persons
in order to avoid a hazard. Respect the minimal
distances between the device and the walls, the
ground, the furniture etc. (as requested in the
picture)
1. Fix the two brackets to the bottom and rear
of the unit.
2. Fix the two top brackets on the wall.
3. Assembly the convector to the wall. Marking
the hole of two bottom brackets.
4. Remove the convector.
5. Drill the two bottom holes and insert the plastic
anchorage.
6. Assembly the convector to the wall again, and
fix the two bottom brackets.
Caution: Double check the safe distance between
the floor and the appliance.