Use And Operation - Klarstein 10031577 Bedienungsanleitung

USE AND OPERATION

Electronic Model
NOTE: For first time operation.there will have some smell.because this Heater have
some protective oil on the surface of the heating element during production.
The Heater may be operated by the manual controls located on the front of Heater or by
your remote control.
1 Carefully remove the Heater from the plastic bag and the carton.
2 Place the Heater on a stable flat surface.
3 Set the Main Power Switch to OFF position. Plug the Power Cord into an electrical
outlet.turn the Main Power switch to ON position. A Beep‚ and the LED display will
light on two second and the Heater is ready to use.
4 POWER button: turn on or off the heater, or cancel some functions settings (such as
timer on/off, etc.).
(a) when standby , this key is to turn on the heater, heater will run according to the
last shutdown mode.
(b) when heater operation, this key is to turn off the heater, make it into standby
mode, display all closed.
(c) when heater in timer on/off status , this key is to cancel the timer setting.
(d) when the first time turn on , defaults to auto mode, the default setting
temperature 18°C.
5 FAN button: the operation of this key ‚i s to start/ stop the fan.
(a) when standby , this key is to turn on the heater, heater will run according to the
last shutdown mode.
(b) when heater operation, this key is to turn off the heater, make it into standby
mode, display all closed.
(c) heater at low power operation, can be artificially set whether to enable the fan,
the fan can run or stop when touch this button.
5 INCREASE button: When setting temperature operation, corresponding (1°C)
in ascending order, the temperature setting range 5°C - 45°C. When setting
a timer operation is to adjust the number of hours corresponding to ( 1 hour) is
incremented, cyclic variations in the timing set within 1 to 23 hours.
EN
17