Warning - Batteries - Hama RCR 110 Bedienungsanleitung

Thank you for choosing a Hama product.
Take your time and read the following instructions and information
completely. Please keep these instructions in a safe place for
future reference. If you sell the device, please pass these operating
instructions on to the new owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to draw
your attention to specific hazards and risks.
Note
This symbol is used to indicate additional information or
important notes.
2. Package Contents
• RC 110 radio-controlled alarm clock
• 2 AA batteries
• 230 V power supply unit
• These operating instructions
3. Safety Notes
• The product is intended for private, non-commercial use only.
• Protect the product from dirt, moisture and overheating, and
only use it in a dry environment.
• Do not use the product in areas where the use of electronic
devices is not permitted.
• Only connect the product to a socket that has been approved
for the device. The socket must be installed close to the product
and easily accessible.
• Do not drop the product and do not expose it to any major
shocks.
• Do not attempt to service or repair the product yourself. Leave
any and all service work to qualified experts.
• Do not modify the product in any way. Doing so voids the
warranty.
• Keep the packaging material out of the reach of children due to
the risk of suffocation.
• Dispose of packaging material immediately according to locally
applicable regulations.
Warning – Batteries
• Immediately remove and dispose of dead batteries from
the product.
• Only use batteries (or rechargeable batteries) that match
the specified type.
• Do not mix old and new batteries or batteries of a different
type or make.
• When inserting batteries, note the correct polarity (+ and -
markings) and insert the batteries accordingly. Failure to do
so could result in the batteries leaking or exploding.
• Do not overcharge batteries.
• Keep batteries out of the reach of children.
• Do not short circuit the batteries/rechargeable batteries and
keep them away from uncoated metal objects.
Warnung
• Only connect the product to a socket that has been
approved for the device. The electrical socket must always
be easily accessible.
• Connect the product to the network using an easily
accessible socket.
• Do not continue to operate the device if it becomes visibly
damaged. (This is mandatory for all products with 220 V
mains connections.)
4. Getting Started
4.1. Inserting the batteries
• Open the battery compartment (14) and remove the contact
breaker. Replace the battery compartment cover.
4.2. Replacing the batteries
• Open the battery compartment (14), remove and properly
dispose of the dead batteries and insert two new AA batteries
with the correct polarity. Replace the battery compartment cover.
4.3. Power supply
• First connect the power supply unit to the socket (10) of the
alarm clock and then to an approved mains socket.
Note
• Sustained projection is only possible on mains power.
• However, batteries are required even on mains power, since
the other functions of the alarm clock are powered by the
batteries.
3