Dimensions; Default Settings; Error Messages - Checkline Ne214 Betriebsanleitung

6.1 Dimensions

6.2 Default settings

The following parameters are programmed into the counter by the
factory, prior to delivery:
Preset value, main counter P1
Preset value, main counter P2
Start count value
Scaling factor, main counter XP
Display
Pulse signal time, main counter
Counting mode
Inputs, main and totalizing counter Track A and UP/DOWN on track B
Change of preset
Counting frequency

6.3 Error messages

Fault must be rectified by the factory.
Excessively fast sequences, e.g. inadequate intervals between
presets at high counting frequency; counting frequency for track A or
B too high.
● Error message
www.checkline.eu
100
1000
0
1.0000
No decimal point
0.25 s
Operating mode 0 (stage preset)
Effective immediately
10 kHz
can be cleared with the
NE214
key.
51