Operating Mode - Checkline Ne214 Betriebsanleitung

4 Operating mode

The operation and use of the counter are described in this section.
● As soon as the power supply has been switched on, the counter
is automatically set to the operating mode.
In the operating mode:
- the current counter status can be read and reset;
- the input preset values can be read and changed if required;
- the overall total can be read and reset;
- the start count value can be read and changed if required;
- the operating hours counter can be read and reset.
All the parameters can be disabled in the programming mode.
Current main counter status XP
Read counter status „XP".
➜
Reset
Press the
➜
Preset value P1
Press the
➜
The preset value P1 can be read off in the display.
Enter preset value P1 with keys
➜
Sign possible following release in line 38.
Press the
➜
To change
● Change completed.
Preset value P2
Press the
➜
The preset value P2 can be read off in the display.
Enter preset value P2 with keys
➜
Sign possible following release in line 38
Press the
➜
To change
● Change completed.
Start count value „SC"
Press the
➜
The current start count SC can be read off in the display.
Enter start count SC with keys
➜
Sign possible following release in line 38
Press the
➜
To change
● Change completed.
Totalizer „∑"
Press the
➜
The current total value can be read off in the display.
Reset
Press the
➜
Hour counter „ "
Press the
➜
The hour counter can be read off in the display.
Reset
Press the
➜
If a key is not operated within 15 seconds, the previous value will
automatically be re-displayed.
key.
key.
key.
key.
key.
key.
key.
key.
key.
key.
key.
www.checkline.eu
and .
and .
and .
NE214
37