Operating Modes - Checkline Ne214 Betriebsanleitung

NE214
Line 65
Line 66
Switching back ➜ Press and hold the
programming lines
Deactivate programming
Reprogram the counter
to the default settings
Step reset
Main preset
Parallel comparison On reaching the preset values, the outputs switch to continuous
P1 Self-adjusting preset
44
Assignment of upper analog limit
0 * Variable value from line 66
1 SC
2 P1
3 P2
Upper analog limit
4095 * Default
-999999 Min.
999999 Max.
The dashed line represents the end of the third program field.
➜ Press the
key.
● The counter is on the operator level.
➜ Switch on the instrument and press the
simultaneously.
● All the programmed values will now revert to their default
settings. The message„Clr Pro" appears briefly in the display.
5.1 Operating modes (line 22)
The operating modes are described below.
On reaching a preset value, the counter continues to count to the
next preset value. Preset values are always processed in the sequen-
ce: preset value 1 and 2. Any values can be chosen. Automatic reset-
ting to the start count value can be obtained with the second preset
value. External or manual resetting can be carried out at any time.
On reaching the individual preset values, the counter is reset to the
start count value. Preset values are always processed in the sequen-
ce: preset value 1, preset value 2. Automatic resetting to the start
count value can be obtained with P2. External or manual resetting
can be carried out at any time.
signals if the respective preset value in either counting direction is
exceeded. Any preset values can be chosen; they are processed in-
dependently of each other. Pulse signals cannot be given in the par-
allel comparison mode.
Preset value P1 serves as a preliminary signal and functions as a
self-adjusting preset. The preliminary signal always switches to the
input value before the final signal is given. Any second preset value
can be chosen.
www.checkline.eu
key and press the key repeatedly.
and